Amirkabir University of Technology Amirkabir Journal of Mechanical Engineering 2008-6032 52 2 2020 04 20 Chemical and Physical Effects of Carbon Dioxide Injection with Different Preheating Temperature in Flameless Combustion Chemical and Physical Effects of Carbon Dioxide Injection with Different Preheating Temperature in Flameless Combustion 311 328 2966 10.22060/mej.2018.13901.5749 FA Esmaeil Ebrahimi Fordoei PHD Student in Tarbiat Modares University Kiumars Mazaheri Faculty of Mechanical Engineering, Tarbiat Modares University Journal Article 2018 01 02 The purpose of the present study is the numerical simulation of the flameless burner with carbon dioxide injection into the oxidizer stream using OpenFOAM software. Also, the effect of different amounts of oxidizer preheating temperature has been studied. In order to perform simulations from the partially stirred reactor combustion model, the standard k-ε turbulence model with modified coefficients and discrete phase radiation model with the calculation of adsorption and emission coefficients using weighted sum of gray gases mode model with non-gray gas coefficients have been used. The results of the present study indicate that the physical effects of carbon dioxide degradation will reduce the amount of heat release and the amount of carbon monoxide produced, while the chemical effects of this injection result in a significant increase in these amounts. Increasing the mass fraction of injection from 0.25 to 0.75 leads to a change in the maximum mass fraction of carbon monoxide produced from 0.05 to 0.072. Also, the chemical effect of the injection changes the flame structure and increased carbon monoxide emissions by increasing the preheating temperature. The chemical effect of carbon dioxide injection on the production of NOx pollutants is such that, with increasing temperature, the amount of NOx emission is increased. The purpose of the present study is the numerical simulation of the flameless burner with carbon dioxide injection into the oxidizer stream using OpenFOAM software. Also, the effect of different amounts of oxidizer preheating temperature has been studied. In order to perform simulations from the partially stirred reactor combustion model, the standard k-ε turbulence model with modified coefficients and discrete phase radiation model with the calculation of adsorption and emission coefficients using weighted sum of gray gases mode model with non-gray gas coefficients have been used. The results of the present study indicate that the physical effects of carbon dioxide degradation will reduce the amount of heat release and the amount of carbon monoxide produced, while the chemical effects of this injection result in a significant increase in these amounts. Increasing the mass fraction of injection from 0.25 to 0.75 leads to a change in the maximum mass fraction of carbon monoxide produced from 0.05 to 0.072. Also, the chemical effect of the injection changes the flame structure and increased carbon monoxide emissions by increasing the preheating temperature. The chemical effect of carbon dioxide injection on the production of NOx pollutants is such that, with increasing temperature, the amount of NOx emission is increased. https://mej.aut.ac.ir/article_2966_65a31da7ede4dc9b03fb5bbf8f442ce9.pdf