Amirkabir University of Technology Amirkabir Journal of Mechanical Engineering 2008-6032 44 1 2012 08 22 Experimental Study of the Effect of Firing Rate and Equivalence Ratio on Performance of a Porous Metal Radiant Burner Experimental Study of the Effect of Firing Rate and Equivalence Ratio on Performance of a Porous Metal Radiant Burner 35 46 49 10.22060/mej.2012.49 FA Seyed Abdolmahdi Hashemi 0000-0001-7169-7173 Majid Nikfar Rohollah Motaghedi Fard Journal Article 2014 03 15 In this paper, the performance of a metal porous radiant burner is investigated experimentally. To study the effect of firing rate and equivalence ratio, some tests have been carried out in five different firing rates and in a range of equivalence ratios which the flame is stable in the porous media. These parameters have been investigated on three porous media, which are formed from fine and coarse  meshes. The results show that the surface temperature increases with increasing firing rate. In each firing rate, the equivalence ratio corresponding to the maximum temperature is determined.  The maximum temperature occurs in equivalence ratios less than one (0.7-1) and Radiation efficiency of the burner decreases with increasing firing rate. The maximum radiation efficiency takes place in equivalence ratio corresponding to the maximum surface temperature. In a specific firing rate, the maximum temperature for the combined porous media (two layers of fine mesh and one layer of coarse mesh) occurs in an equivalence ratio less than that of the other porous media. Listen Read phonetically The obtained results are in a good agreement with the other studies.  In this paper, the performance of a metal porous radiant burner is investigated experimentally. To study the effect of firing rate and equivalence ratio, some tests have been carried out in five different firing rates and in a range of equivalence ratios which the flame is stable in the porous media. These parameters have been investigated on three porous media, which are formed from fine and coarse  meshes. The results show that the surface temperature increases with increasing firing rate. In each firing rate, the equivalence ratio corresponding to the maximum temperature is determined.  The maximum temperature occurs in equivalence ratios less than one (0.7-1) and Radiation efficiency of the burner decreases with increasing firing rate. The maximum radiation efficiency takes place in equivalence ratio corresponding to the maximum surface temperature. In a specific firing rate, the maximum temperature for the combined porous media (two layers of fine mesh and one layer of coarse mesh) occurs in an equivalence ratio less than that of the other porous media. Listen Read phonetically The obtained results are in a good agreement with the other studies.  https://mej.aut.ac.ir/article_49_f457c545a9ded88f18ecee47145a72c0.pdf