Plugging of Metallic Plates under Normal Impact of Deformable Projectiles

Document Type : Research Article

Authors

Abstract

In this paper, the plugging failure of metallic plates under normal penetration of deformable projectiles has been analyzed by considering plastic stress wave theory. The material behaviors of plate material and projectile are considered rigid- plastic linear work hardening. In this model based on propagation of plastic stress waves in projectile, plug and outer region of plug, the penetration process is divided in six steps and governing equations at each step are derived. The results of analytical model are compared with experimental results and modeling by LS-Dyna software. The residual velocity, flattening area of projectile, penetration time and ballistic limit velocity predicted by new analytical model are good agreement with experimental results.

Keywords


[1] Backman M.E. , Goldsmith W., “The Mechanics of Penetration of Projectiles Into Targets”, Int. J. Eng. Sci., Vol. 16, p.p.1-99,1978.
[2] Corbett G.G. , Reid S.R. , Johanson W., “Impact Loading of Plates and Shells By Free- Flying Projectiles, A review”, Int. J. Impact Eng., Vol. 18,N. 2, p.p. 141-230, 1996
[3] Recht R.F.,” Taylor Ballistic Impact Modeling Applied to Deformation and Mass Loss Determinations”, Int. J. Eng. Sci., Vol. 16, p.p.809-827, 1978.
[4]  Wenxue Y. , Lanting Z., “Plate Perforation By Deformable Projectiles- A Plastic Wave Theory,”Int. J. Impact Eng., Vol. 1,N. 4,p.p. 393-412, 1983.
[5] Liss J. and W. Goldsmith, Plate Perforation Due to Impact By Blunt Cylinders, Int. J. Impact Eng., 2, 1, 37-64, 1984
[6] Maudlin P.J., Foster J. C., Jones S.E.,” A continuum mechanics code analysis of steady plastic wave propagation in the Taylor test”, Int. J. Impact Eng. , Vol. 19,N. 3, p.p. 231-256, 1997.
[7] لیاقت، غلامحسین، نائینی، حسن مسلمی و فعلی، سعید،"تحلیل نفوذ عمودی پرتابههای تخت تغییر شکلپذیر در اهداف فلزی نازک تا نیمه ضخیم"، نشریه پژوهشی مهندسی مکانیک ایران، سال پنجم، شماره اول، صفحه 35-53، 1382
[8] لیاقت، غلامحسین، نائینی، حسن مسلمی و فعلی، سعید،"تحلیل نفوذ پرتابههای تغییر شکلپذیر در اهداف فلزی بکمک تئوری امواج تنش پلاستیک"، نشریه امیرکبیر،سال پانزدهم، شماره ب-57، صفحه 84-1382،100.
[9] Liaghat G. H., Moslemi Naeini H. , Felli S. “The mechanics of normal and oblique penetration of conical projectiles into multi layer metallic targets”, Iranian J. of Sci. & Tech., Trans. B, Eng., Vol. 29, N. B2, 2005.
[10] Zukas J.A.,” High Velocity Impact Dynamic”, John Wily and Sons, 1990.
[11] نوری تبار، اسد، "بکارگیری امواج تنش پلاستیک در تحلیل فرایند نفوذ پرتابههای تغییر شکل پذیر در اهداف فلزی"، پایان نامه کارشناسی ارشد دانشگاه رازی، 1387
[12] M. J. Forrestal and S. Hanchak, “Penetration experiments on HY-100 steel plates with 4340 Rc 38 and maraging T-250 steel rod projectiles”, Int. J. Impact Eng., Vol. 22, p.p. 923-933, 1999.